Just catching up with the Forum DLL - yes, I'm slow. I had a questions regarding a statement in the Forum DLL Manual. In particular, the code for Exit Long (similar for exit short) which is given as B=0 AND Ref(B,-1)=1. This doesn't seem to work where a long exit is the same signal as a short entry, as B goes directly from +1 to -1. i changed the code to B<1 AND Ref(B,-1)=1 and then it worked. Simlar in reverse for Short Exit. Sorry if this is a well-known issue - I didn't find anything on it in a quick scan and I'm months behind on Roy's newsletter... Andrew

This is the right forum for this post ... If you are using an expert I would simply tell you to move both the entry signals above the exit signals so that in your expert the order is similar to : Enter Long Enter Short Exit Long Exit Short Then the use of B=0 AND Ref(B,-1)=1 should be just fine. Patrick :mrgreen:

Andrew, Are you using the 'original' forum latch from the downloads section, or the revised latch from http://forum.equis.com/viewtopic.php?t=3735 ? If the original, then it has some minor issues with how it handles different scenarios such as entry and exit on the same bar; if the you managed to grab the revised version during the time when I had it posted (I got next to no feedback, so I don't know if you have it) then its truth table is on the forum to show how it handles same day entry and exits. wabbit :D P.S. At some time, Patrick was going to issue a new consolidated Forum.dll as the latest revision. I don't know what happened to this project, but he has been busy with other things! When the new release comes out, I will update the documentation.